![]() Shop Bass Tuning Machines INTONATION (ROUGHING IT OUT) For five-string basses, cut the fifth string 3 1/2" (89 mm) past its tuning post and repeat the same cutting and winding procedure. Pull the second and first strings 4 1/2" (114 mm) past their tuning posts and cut and wind as noted. Pull the third string 4 1/2" (114 mm) past its tuning post, cut it, and repeat the winding procedure. Insert into the center hole of the tuning key, bend and crimp to a 90° angle, and wind neatly in a downward pattern, being careful to prevent overlapping. Pull the fourth string 4" (102 mm) past its tuning post and cut it (again, make sure to pull each string taut). Pre-cut each string for the proper length and desired amount of winds. For five-string basses, cut the fifth string 3" (76 mm) past its tuning post and repeat the same cutting and winding procedure. Pull the second and first strings 3 1/2" (89 mm) past their tuning posts and cut and wind as noted. Pull the third string 3 1//2" (89 mm) past its tuning post, cut it, and repeat the winding procedure. ![]() Insert through the eyelet in the tuning key, allowing approximately 1/16" (1.6 mm) of the end to extend through the eyelet, then wind neatly in a downward pattern, being carefull to prevent overlapping. Pull the fourth string 3" (76 mm) past its tuning post and cut it (make sure to pull each string taut). Start by loading them through the bridge and then loading them onto the appropriate keys as follows: How you wind the strings onto the pegs is very important. After the whole set is changed and tuned, stretch your strings properly by holding them at the first fret and hooking your fingers under each string (one at a time) and then tugging lightly, moving your hand from the bridge to the neck. They are available in long, medium and short scales taper-wound and top-loading or string-through-body typesīecause of the amount of tension on the neck, it's advisable to replace and tune each new string before removing the next string. If you find any of these, you should change your strings.įender offers a variety of bass strings-smooth, vintage-sounding pure-nickel Original Bass 7150s Super Bass 7250s bright, snappy Stainless Steel 7350s and others. To check if your strings need changing, run a finger underneath the string and feel for dirt, rust or flat spots. Strings that have lost their integrity (worn where pressed against the fret) or have become oxidized, rusty and dirty will not return to pitch properly. For strings to stay in tune, they should be changed regularly. Much of the thump and pop you expect from your bass starts right there. New strings can breathe new life into your bass. ![]() Light machine oil (3-in-1, toy locomotive or gun oil).Shop Care & Cleaning Products TOOLS NEEDED Note: These are minimum specifications that are meant as a guide they should not be construed as hard and fast rules, as we realize that every player's subjective requirements often differ. Modifications of the specs may also be made (within limited parameters) to adjust for your individual playing style or application (i.e., how hard you pick, finger, slap, pop or fret the bass). If you plan to change string gauges, you may need to adjust the specs somewhat to compensate for the changes in string sizes. The following setup procedures and specifications are for you Fender bass as equipped with the strings that come on the instrument as standard equipment from the factory. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |